Type 1 - 13W Supported by PSEs of Type: 1, 2, 2 Twin, 3, 3 Twin
PoH PSE
-
The WP-580TXR is an extended range, HDBaseT twisted pair wall plate transmitter for HDMI signals. The WP-580TXR inputs HDMI signals and converts them into an HDBaseT twisted pair signal that it transmits to a WP-580RXR receiver.
Max. Data Rate - 10.2Gbps (3.4Gbps per graphic channel)
HDTV Compatible.
HDCP Compliance.
HDBaseT™ Technology.
HDMI Support - Deep Color, x.v.Color™, Lip Sync, HDMI Uncompressed Audio Channels, Dolby TrueHD, DTS?HD, CEC.
3D Pass-Through.
EDID PassThru - Passes EDID signals between the source and display.
2K & 4K Support.
System Range - Up to 130m (430ft) normal mode; up to 180m (590ft) Ultra mode (1080p @60Hz @24bpp) when using BC-DGKat623 cables.
Cable - Requires shielded twisted pair (STP) cable. For optimum range and performance use, use Kramer's BC?DGKat524, BC?DGKat623 and BC-DGKat7a23 cables. Note that the transmission range depends on the signal resolution, graphics card and display used. The
Indicators - Status LEDs for input, output, link and power.
Dimensions - 12.4cm x 3.12cm x 7.9cm (4.88" x 1.29" x 3.12") US; 15.1cm x 2.96cm x 8.6cm (5.95" x 1.17" x 3.39"), 15.1cm x 2.96cm x 8.0cm (5.95" x 1.17" x 3.15") EU (W, D, H).
Wall Plate Size - 2 gang EU/US.
HDBaseT - Yes
Receiver/Transmitter Cable Type - Twisted Pair
Receiver/Transmitter Format Type - HDMI
Supported Resolution - 2K (2048x1080)
Supported Resolution - 4K (4096x2400)
TX RS-232 - No
MAX. DATA RATE:
10.2Gbps (3.4Gbps per graphic channel)
EDID PassThru:
Passes EDID signals between the source and display.
Support:
2K & 4K Support.
System Range:
Up to 130m (430ft) normal mode; up to 180m (590ft) Ultra mode (1080p @60Hz @24bpp) when using BC?DGKat623 cables.
Cable:
Requires shielded twisted pair (STP) cable. For optimum range and performance use, use Kramer's BC?DGKat524, BC?DGKat623 and BC?DGKat7a23 cables. Note that the transmission range depends on the signal resolution, graphics card and display used. The distance using non?Kramer CAT 5, CAT 6, and CAT 7 cables may not reach these ranges. Use only shielded cable where both ends of the shield are soldered to ground.
Indicators:
Status LEDs for input, output, link and power.
Dimensions:
12.4cm x 3.12cm x 7.9cm (4.88" x 1.29" x 3.12") US; 15.1cm x 2.96cm x 8.6cm (5.95" x 1.17" x 3.39"), 15.1cm x 2.96cm x 8.0cm (5.95" x 1.17" x 3.15") EU (W, D, H).